Scroll saw wood can jump sometimes because of the way it’s cut.
When you cut a piece of wood on a scroll saw, the blade goes up and down. If the blade is going down when it hits a knot in the wood, the force can cause the wood to jump up. This is more likely to happen with hardwoods like oak or maple.
Scroll sawing is a great way to make precise cuts in wood. You can use it to make things like boxes, puzzles, and other small projects. With a little practice, you can get good at avoiding jumps altogether.
Why Does Scroll Saw Wood Jump Sometimes?
When sawing wood on a scroll saw, it’s not uncommon to experience the wood jumping up out of the saw’s cutting path. While this can be frustrating, there are a few things you can do to help minimize this problem.
One of the main reasons scroll saw wood jumps is because the blade is too dull. A sharp blade will make cleaner cuts and reduce the amount of vibration that occurs when the blade passes through the wood. It’s important to keep your blades sharpened regularly so that they cut cleanly and don’t cause the wood to jump.
Another reason scroll saw wood jumps is because the table isn’t level. When the table isn’t level, it can cause the wood to shift as it’s being cut, which can cause it to jump out of the saw’s path. Make sure to check the table for levelness before you start cutting and adjust it as necessary.
Finally, if the blade is too deep into the wood, it can cause the wood to jump up out of the saw’s path. Make sure to adjust your depth cut accordingly, so that the blade is just barely cutting into the wood. This will help reduce vibration and minimize the chances of the wood jumping out of the saw’s path.
Conclusion
By following these tips, you can help reduce the amount of scroll saw wood jumping that occurs while you’re cutting. Stay patient and take your time, and you’ll be able to make clean, precise cuts every time.